AQUA GUARD ANTI HUMIDITY PAINT-1K

AQUA GUARD ANTI HUMIDITY PAINT-1K

DEFINITION
A very strong moisture and mold insulation paint produced by modifying with special chemicals and polymers for the elimination of moisture and humidity problems caused by natural conditions on the interior and exterior walls of buildings.

CONSUMPTION
Minimum total consumption: 0.5 -0.8 kg/m2

Usage Areas
• Wet and damp walls
• On painted or unpainted damp walls
• On interior and exterior walls,
• On basement floor walls,
• On surfaces and floors such as plaster, plaster, concrete, screed,
• In tunnels,
• On the northern facades of the buildings,
• Humidity and humidity problems.

FEATURES
• It can be applied to all kinds of wet, damp or dry walls, painted and unpainted surfaces. Thanks to its excellent alkali and moisture resistance, it prevents the formation of dampness and moisture on the walls, and destroys them, if any.
• Its adhesion strength to all kinds of surfaces is extremely strong, it never peels off, does not swell, and has very good resistance to chemicals.
• It is not affected by UV, rain, water, salt.
• It forms film layers with excellent water resistance on interior and exterior walls, flooded buildings, basements, garages or cellars, on the north-facing surface where it is used.
• Even if the paint or wall is damp or even wet, it clings to the surface very tightly, dries quickly and provides insulation.
• It is not affected by salt water and salt vomit. Due to this feature, it is also used to solve the problem of paint blistering in flooding of buildings.
• While creating a waterproof layer on the surface where the moisture paint is applied, it also penetrates into the wall and dries the moisture inside thanks to its special chemicals. Thus, it provides drying inside the wall where it is applied.
• Moisture paint has no side effects. Therefore, it does not cause any chemical damage to the surface or materials to be applied.
• NEM paint is ready to use,
• Does not require primer.
• The application surface may be damp, damp or dry.
• It can be applied to any painted or unpainted surface.

APPLICATION AND SURFACE PREPARATION
Layers that will reduce adherence such as oil, grease, dirt, paint, cement grout, rust, mold oil, salt bleed should be thoroughly cleaned before application. The surfaces must be clean, sound, free of carrier and free particles. Cracks and fractures on the surface should be carefully repaired with repair mortars and the surface should be prepared. It is a ready-made material; Heating does not require thinning. It should be applied after the material is mixed very well. Gloves must be used during the application. It is applied with a brush or roller. Final curing takes place in 5 days.

APPLICATION
• It is a ready-made material; Heating does not require thinning.
• It should be applied after the material is mixed very well.
• Gloves must be used during the application.
• It is applied with a brush or roller.
• Final curing takes place in 5 days.
• At least two coats of application are required.
• The second layer should be applied after at least 12 hours.
• It should not be applied in rainy weather or at temperatures below 5°.

PACKAGING AND CONSUMPTION
5 kg liquid is presented ready to use in plastic packaging.

CLEANING
Tools and equipment are cleaned with water.

SHELF LIFE
24 months from date of manufacture if stored in original, unopened and undamaged packaging.

WARNING AND PRECAUTIONS
• The application area must be well ventilated.
• The newly applied material should not be exposed to rain and frost for 24 hours.
• It should not be applied under 5°, rainy and foggy weather.
• Do not apply on wet and frozen surfaces.
• Pay attention to the safety signs and warnings on the packaging.
• Adequate ventilation should be provided in the workshops and open flames and high temperatures should be avoided.
• Mix well before application and do not leave the lid of the package open.
• Avoid application in weather conditions where precipitation is expected and under precipitation.