AQUA GUARD LATEX POLYMER-1K

AQUA GUARD LATEX POLYMER-1K

DEFINITION
Cement based plaster, screed, repair etc. It is an acrylic polymer-based liquid additive that provides adhesion and water impermeability added to mortars. It increases the quality of mortar and concrete by increasing high quality bond strength, reducing shrinkage, providing high elasticity and friction resistance. It is non-toxic and can be diluted with water.

Usage Areas
• In plasters and wall mortars,
• In floor screeds,
• In gross concrete,
• In concrete and thin layer repair mortars,
• In ceramic adhesive mortars,
• On wear resistant coatings.

FEATURES
• Increases bond strength in hardened concrete.
• Increases waterproofing.
• Reduces shrinkage.
• Increases the flexibility of the mortar.
• Provides friction resistance.
• Increases adhesion on most substrates.

APPLICATION
It is recommended to use the following dimensions depending on the place and purpose of use. Before the application, a latex/water mixture is prepared and added to the cement/sand mixture prepared at a ratio of 1/3 in sufficient amount to increase the adhesion to the surface. Then the mixture is applied to the surface or floor with a brush. It should be applied before it dries. For adherence: Aqua Guard Latex is mixed with water at a one-to-one (1/1) ratio and cement is added on it until it reaches the consistency of boza. The resulting cement grout is applied by brushing or pouring onto the surface. Plaster or screed should be applied on it before it completely dries.

MIXING
Mix the concrete with sand, add AQUA GUARD LATEX POLYMER and continue mixing for at least 2-3 minutes. Then add a small dose of water.

CAUTION
AQUA GUARDLATEX POLYMER provides concrete with fluidity and plasticity, therefore the amount of water must be reduced to compensate with the addition of LATEX.

PACKAGING AND CONSUMPTION
25 kg liquid is presented ready to use in plastic packaging.