INNOPUR SEAL PU BITUMEN SELF-2K

INNOPUR SEAL PU BITUMEN SELF-2K

DEFINITION
INNOPUR SEAL PU BITUMEN SELF-2K is a two-component, bitumen-enriched, self-leveling polyurethane-based, ideal filling material with high performance developed for horizontal joints. It adheres strongly to almost any surface, forming a highly elastic layer. Its resistance to chemicals and mechanical effects is excellent. Its content is based entirely on elastomeric hydrophobic polyurethane resin and supported by chemically polymerized pure bitumen. It has excellent resistance to different climatic and heat conditions. In addition to its effective waterproofing feature, it also shows very good resistance against chemicals and other destructive factors.

USAGE PLACES
- In horizontal joints
- Joints of airport runways
- Roofs made of cement
- Metal or fibrous roofs
- Water tanks (excluding drinking water tanks)
- floors
- Fundamentals
- Bridge platforms
- Cut-and-cover tunnels
- Irrigation channels

ADVANTAGES
- Cures fast.
- Thick coat can be applied, it does not form bubbles.
- Unmixed components other than the application amount can be stored for later use.
- Because of its low modulus, crack bridging feature is excellent.
- It exhibits effective resistance against chemicals.
- Although it does not need to be thinned, it can be thinned with polyurethane thinner depending on the conditions.
- Its thermal resistance is excellent, the product never softens.
- Maximum usage temperature is 80°C, maximum shock temperature is 200°C.
- Resistant to cold, the film maintains its elasticity down to -40 °C.
- It has excellent mechanical properties.
- Acts effectively as a water vapor barrier

APPLICATION
Environmental Conditions The relative humidity of the air should be 80% maximum, and the application temperature (environment and surface) should be between +3°C and +35°C. It should not be rainy 24 hours before, during and 24 hours after the application in open areas.
The ground temperature should be 3°C above the current dew (dew falling) temperature.

Surface types that can achieve successful results: Concrete, fiber cement, mosaic, cement-based roof tiles, old but well-adhered acrylic and asphalt coatings, wood, corroded metal and galvanized steel surfaces. For other substrates, please contact our technical department.

SURFACE PREPARATION
The surface should be cleaned using pressurized water if possible; Oil, grease, fuel and paraffin wastes should be removed, as well as completely free from mold release agents, cement residues, chips, loose particles and cured membranes. Mixing Equal amounts of two components should be removed by hand or with a mixer operating at low speed (300 rpm). After mixing, apply immediately with a trowel. The pot life of the mixture is 25-30 minutes at 20°C.

Application
Apply the material with a trowel.

PACKING INFORMATION
In sets of 10 kg and 20 kg

STORAGE CONDITIONS
The material should be stored in a cool and dry place. The life of the material is 1 year for components A and B when stored properly and in its unopened original packaging.