INNOPUR SHIELD POOL PAINT-2K

INNOPUR SHIELD POOL PAINT-2K

DESCRIPTION
An acrylic polyurethane resin-based, solvent-borne, two-component pool paint. It is resistant to ultraviolet rays, abrasion, and continuous water contact. Applied on floors and walls in decorative pools, ponds, parking lots, and garages.

CONSUMPTION
Minimum total consumption: 0.2 - 0.4 kg/m²

APPLICATION AREAS
• In swimming pools
• In ponds
• In places where mechanical and chemical resistance is required,
• In industrial structures under open atmosphere and sunlight,
• In places where gloss and durability are desired.
• On terraces, balconies, and wet floors,
• On concrete or metal surfaces,
• On polyurethane, polyurea, and epoxy coated surfaces,
• As a topcoat in many outdoor areas due to its UV resistance,
• Can be used in indoor and outdoor swimming pools.

FEATURES
• Ready-to-use liquid form.
• Hard yet elastic, does not crack.
• High adhesion.
• Excellent adhesion even to old coatings.
• Not harmful to human health.
• Provides pedestrian traffic resistance with its mechanical strength.
• Does not soften in summer or harden in winter.
• Resistant to water and chemical substances.
• Penetrates surfaces very well.
• Resistant to severe weather conditions and certain chemicals.

APPLICATION
Layers reducing adhesion such as oil, grease, dirt, paint, cement laitance, rust, form oil, and salt efflorescence must be completely cleaned before application. Surfaces must be clean, sound, load-bearing, and free from loose particles. Cracks and damaged areas on the surface must be carefully repaired with repair mortars. After surface preparation, priming should begin. To ensure the success of the polyurethane coating to be applied over it, all pores on the surface must be completely sealed. PU PRIMER-1K / EPOXY PRIMER can be preferred as a primer. Application components A and B should be mixed paying attention to mixing ratios, preferably using a low-speed mixer for at least 3-4 minutes until homogenous. The prepared product should be applied to the primed surface by roller, brush, or spraying. Application should be done in at least two coats, waiting 12-24 hours between coats. The applied area must be protected from water for at least 4-6 hours. It is a two-component material. Does not require heating or thinning. Gloves must definitely be worn during application. Should not be applied in rainy weather or temperatures below +5°C.

PACKAGING
Component A: 8 kg + Component B: 2 kg Total: 10 kg set

CLEANING
Tools and equipment should be cleaned with thinner.

SHELF LIFE
Can be stored for at least 12 months in dry, unopened original packaging at temperatures between 5-25 °C. Once opened, use as soon as possible. Protect from freezing conditions.

WARNINGS AND PRECAUTIONS
• Newly applied material should not be exposed to rain and frost for 24 hours.
• Should not be applied below (+)5°C, in rainy or foggy weather.
• Do not apply on wet and frozen surfaces.
• Pay attention to safety signs and warnings specified on the package.
• Adequate ventilation should be provided in workshops, keep away from open flames and high heat.
• Mix thoroughly before application. Do not leave the package lid open.
• Avoid application under weather conditions where rain is expected or occurring.
• Avoid contact with skin, eyes, and mouth, and apply by taking necessary occupational safety precautions.