AQUA GUARD LATEX POLYMER-1K

AQUA GUARD LATEX POLYMER-1K

DESCRIPTION
An acrylic polymer-based liquid additive that provides adhesion and waterproofing when added to cement-based plasters, screeds, repair mortars, etc. It improves mortar and concrete quality by increasing high-quality bond strength, reducing shrinkage, and providing high elasticity and friction resistance. It is non-toxic and water-dilutable.

APPLICATION AREAS
• Plasters and masonry mortars,
• Floor screeds,
• Fair-faced concrete,
• Concrete and thin-layer repair mortars,
• Ceramic bonding mortars,
• Abrasion-resistant coatings.

PROPERTIES
• Increases bond strength in hardened concrete.
• Increases water resistance.
• Reduces shrinkage.
• Increases mortar flexibility.
• Provides friction resistance.
• Increases adhesion strength on most substrates.

APPLICATION
Depending on the place and purpose of use, it is recommended to use in the following proportions. Before application, to increase adhesion to the surface, a latex/water mixture is prepared and added in sufficient quantity to a 1/3 ratio cement/sand mixture. Then the mixture is applied to the surface or floor with a brush. Application should be started before it dries. For adhesion: Aqua Guard Latex is mixed with water at a 1:1 ratio, and cement is added until it reaches a thick batter consistency. The resulting cement slurry is applied by brushing or pouring onto the surface. Plaster or screed should be applied before full drying occurs.

MIXING
Mix concrete with sand, add AQUA GUARD LATEX POLYMER and continue mixing for at least 2-3 minutes. Then add a small dose of water.

CAUTION
AQUA GUARD LATEX POLYMER provides concrete with fluidity and plasticity, so the amount of water should be reduced to compensate for the addition of LATEX.

PACKAGING AND CONSUMPTION
Supplied ready to use as a 25 kg liquid in plastic packaging.